Hasport acura rsx rsx-s 2002-2005 honda civic si engine motor mount kit 88a race (fits: 2002 acura rsx) The Hasport Engine Mounts are designed to easily bolt-up a manual transmission equipped DC5 Acura RSX / RSX-S or EP3 Civic Si.

Bump i havent got a reply yet so was finally posting again but i have heard you can run without a front mount with hasport or innovative is that true? None of the Hasport mount kits come with a front engine mount, only the left, right and rear. It is not necessary because the Hasport mounts hold the engine and trans much more firmly than stock.

The stock RSX front mount does fit with the Hasport mounts so you CAN use the stock front mount, but you don't HAVE to. Autobiography of a yogi pdf. With your trans broken the way it is upgrading to aftermarket mounts would be a good idea. I hope this info is helpful. New spectrasonics trillian mac keygen 2016 - free software 2016 free. I will tell you right now, hasport mounts DO NOT hold the engine in a 02 si very well. I had the 62a's with stock front mount and the motor moved enough to tear the front mount up in a weeks time, I went to 70a hasports and still had major engine flop under launching, so I added a 70a innovative front mount and all the wheel hop/ motor flop went away. I believe this is due to stock rear mount placement, on B series cars the T bracket is straight back and hold the motor from lifting, but in rsx/si cars its low down and acts as a leverage point and only gets worse with more power. I have hasports (the 3 they sell in 70a) and innovative front in 70a and my buddy has innovative 70a all around and they feel about the same, mind you I have a k24/k20 without balance shafts and he has a k24/k20 with balance shafts.

Good luck with that, on hasport 70a's and a stock front mount I had motor flop/wheel hop from hell, after adding a innovative front mount all was solved, just keep that in mind. If rsx's and si's had the rear mount straight back like the earlier crx's/civic's/integra's it would be fine as its located at a point that the motor was to overcome alot to move, but with our mount style its down low and acts as a pivot point and with no front mount you will see the mount inserts in the hasports wedging themselves out (I have a post on ephatch that shows pics of this). *edit* if you run like 80 or 85a mounts or pure solid (aluminum or steel insert mounts) you wont have a problem, but anything under that and you will have issues.